Skill drill
Using Another Vehicle as a Winch Anchor
No tree in reach, but a second vehicle on firm ground can be the anchor, as long as it is set so it cannot be dragged.
10 steps, about 3 minutes
Rig it in 3D one decision at a time. Choose wrong and you will see what happens.
When to use it
When there is no natural anchor and another vehicle can park in line on firmer ground. The anchor vehicle has to resist more than the stuck one does, or the pull simply drags it in too.
The steps
- Gear up
- Pick the anchor
- Set the anchor vehicle
- Spool out
- Connect
- Damper on
- Clear the area
- Take up the slack
- Winch it out
- Secure and spool in
A drill is practice, not certification. Read your own winch's manual, and learn it hands-on from someone experienced before you rely on it.
The written guide
Step by step
- 1
Gear up
Put on heavy leather gloves and clip the hook strap to the hook. Use the strap any time you handle the hook, never let the line slide through your hands, and never hold the hook itself.[1, 3, 4]
Winch lines carry burrs and broken strands, and the fairlead is a pinch point. The hook strap keeps your fingers out of it.
- 2
Pick the anchor
Park the anchor vehicle in line with the pull, on the firmest ground available, facing the stuck vehicle.[4, 6]
It has to have more grip than the stuck vehicle has resistance, or you end up with two vehicles sliding toward each other.
- 3
Set the anchor vehicle
Put the anchor vehicle in neutral with the parking brake set, chock its wheels, and keep someone in the driver's seat holding the foot brake.[1, 4, 8]
The anchor vehicle is the whole anchor. If it rolls, the stuck vehicle does not move and the line goes slack and then shock-loads.
- 4
Spool out
Put the winch clutch in free-spool and walk the line out by the hook strap, keeping a little tension on it so it does not kink or tangle. Leave at least 10 wraps of synthetic line on the drum, or 5 of steel.[1, 3]
The point where the line is fixed to the drum is not built to hold load. The wraps hold it. Slack line walked out loosely can twist and wind on badly later.
- 5
Connect
Shackle the hook to a rated recovery point mounted to the anchor vehicle's frame. Never a tow ball, and never the bumper.[4, 5, 6]
Only rated, frame-mounted points are built for recovery loads. A tow ball or a bumper can break off and become a projectile.
- 6
Damper on
Lay a line damper, a recovery blanket or weighted bag, over the middle of the line before you put any tension on it.[1, 2, 3]
If the line or a piece of hardware fails, the damper's weight pulls the line toward the ground instead of letting it whip back at the vehicle. Never walk up to a loaded line to move one; slack it first.
- 7
Clear the area
Before the line takes any load, move everyone back at least 1.5 times the length of line you have out. Nobody stands in front of or behind the vehicle, near the line, or near a snatch block, and nobody steps over the line.[1, 3, 4, 5, 6]
Anyone near a loaded line is in its path if something fails. Sources set the keep-out distance anywhere from the full length of the line to twice it; this drill uses 1.5 times, the Victorian government's figure.
- 8
Take up the slack
Engage the winch clutch, pass the remote cord in through the window, and spool in slowly just until the slack is gone. Stop, and check the anchor, the strap, the shackle and the hook before you load it. Watch the anchor vehicle as the line tightens; if it moves at all, stop.[1, 3]
A slack line that suddenly loads hits the whole rig with a shock. Checking at light tension catches a bad anchor before it carries the full pull.
- 9
Winch it out
Keep the engine running and the transmission in neutral. Winch in steady pulls, pausing to let the motor rest and to check the line is winding evenly onto the drum.[1, 3, 7]
A running engine keeps the battery up under the winch's draw, and short pulls with rests keep the motor from overheating. Jerky loads are the ones that break hardware.
- 10
Secure and spool in
Put the vehicle in park or a low gear before you release the line tension. Then spool in, walking the line with the hook strap so it winds on evenly, and stop with the hook about 3 feet from the fairlead.[3, 4]
The vehicle has to hold itself before the line goes slack. Powering the hook into the fairlead can damage both.
Avoid these
Common mistakes
An anchor vehicle that is not set
Neutral, parking brake, chocks, and someone on the foot brake. Otherwise the pull drags it in.[1, 4, 8]
Hooking to a tow ball or bumper
Rated, frame-mounted recovery points only.[4, 5, 6]
Watch & learn
Vehicle as anchor on video
Picked from our video library. These are other creators' videos, so where one differs from the drill, the drill's sourced steps are the ones to follow.
Proper Winching setup from another vehicle
GearAmerica
0"Oh Hey There!" 21: Two Vehicle Pull with Snatch Block and Respool
Expedition Overland
0It's not what you think...or is it? Using two winches to get a mate unbogged.
Mad Mates
0
Keep practicing
Other winch techniques
Start hereSingle-line pullThe basic self-recovery: one line from your winch straight out to a solid anchor in front of the vehicle.10 steps
Technique 2Double-line pullThe line runs out to a snatch block on the anchor and back to the vehicle, roughly doubling the pull at half the line speed.11 steps
Technique 3Redirect pullWhen the only big anchor is off to the side, a snatch block on a second anchor in front turns the line so it feeds into the winch straight.11 steps
Technique 5Buried anchorOpen ground, no trees, no second vehicle: bury your spare tire across the line of pull and winch to the ground itself.10 steps
Learn it hands-on
Nothing replaces practicing with someone who has done it. Browse off-road tour operators and parks near you and ask whether they run recovery training.
Find off-road tours and parksSources
Where the checkable claims above come from. Rules and figures change, so confirm anything you are about to rely on against the source itself.
- Basic Guide to WinchingWARN Industries (warn.com)
- Basic Winch TechniquesWARN Industries (warn.com)
- The Basic Guide to Winching Techniques (62885A6)WARN Industries (quadratec.com)
- Electric Winch User's GuideSuperwinch (Westin Automotive) (westinautomotive.com)
- SOI-034: 4WD Vehicle Winch (Safe Operating Instructions)Victoria State Government, Department of Environment, Land, Water and Planning (files-delwp.em.vic.gov.au)
- ATP 4-31: Recovery and Battle Damage Assessment and RepairUS Army (published by the North Carolina National Guard) (ng.nc.gov)
- Winch User Guide (9923644)Polaris (publications.polaris.com)
- Automotive Winching ProceduresCOMEUP Industries (comeupwinch.com)
